Replaced the Spring in the Flame Nozzle

Electronic piezo lighters have a spring on top of the flame nozzle from where the flame comes out.

Fallen ashes and other particles such as the dust and lint in your pocket will clog the spring and will prevent the lighter from lighting.  Once a week, use the compressed air to clean the flame hole where the spring is located.  

If the flame of your lighter gets low or does not come up even though the gas tank is full and the flame height adjuster is set at a proper level , clean the flame hole with compressed air such as air duster can sold at computer stores in order to remove any fallen dust or cigar/cigarette ash from the flame hole.  Do this at least once a week or any time that you need to refill the lighter.  Depending on how much air you use to clean the nozzle, you might have to bleed some of the air out by pressing down on the refill nozzle or clicking the lighter a few times. 

The number one cause for the malfunction of the lighter is the clogging of the flame hole where the flame comes out.  Please make sure that you do not carry your lighter in a dirty pocket.  Also, when you light your cigar or cigarette, please do not put them into the burning flame in order to prevent the ashes from falling into the flame hole of your lighter and clogging it up.  In lighting your cigarette, light it with the top tip of the flame.